Short answer
QUIKRETE says to dig the hole three times the post width and as deep as one third of the post length plus 6 in (150 mm) of gravel. For a 6 ft fence on 4 in posts that is a 12 in hole, 42 in deep, and about 5 bags of 50 lb fast-setting mix per post.
Calculate it
Fence calculator
Posts, panels or pickets and rails, concrete per post.
Fence calculator →How deep is the hole?
QUIKRETE gives two versions of the same rule. The setting-posts instructions say the hole depth is one third of the overall post length, plus 6 in (150 mm) for the gravel base. The Fast-Setting Concrete data sheet says the buried part should be half of the post height above ground.
These agree. If a post is 9 ft long with 6 ft above ground, one third of the length is 3 ft, which is half of 6 ft. The gravel comes on top of that: 36 in + 6 in = 42 in (1.05 m) of hole.
Frost depth is a separate matter. Ask your local building department what it requires for posts in your area, and dig deeper if it says so.
How wide is the hole?
QUIKRETE specifies a hole diameter three times the diameter of the post. A 4 in (100 mm) post goes into a 12 in (300 mm) hole, which leaves 4 in of concrete on every side.
A narrower hole saves little concrete and gives a thinner collar. A wider one costs bags quickly, because the volume grows with the square of the diameter.
Gravel at the bottom
Tamp the bottom and sides of the hole firm, then put in 6 in (150 mm) of gravel or crushed stone. QUIKRETE gives the purpose as drainage.
The gravel is part of the hole depth, not extra to it. A 12 in hole with 6 in of gravel is a volume of π × 6² × 6 = 679 in³, or 0.39 ft³ per post (10.6 litres in a 300 mm hole with 150 mm of gravel).
Worked example: ten posts for a 6 ft fence
Posts 4 in (100 mm) square, 6 ft above ground, so 3 ft buried. Holes 12 in across, 42 in deep including the gravel. QUIKRETE says to bring the dry mix to within 3 to 4 in of the top and fill the rest with soil, so the concrete stops 3 in below grade.
- Concrete height: 36 in − 3 in = 33 in.
- Hole area minus post: π × 6² − 4 × 4 = 97.1 in².
- Volume per post: 97.1 × 33 = 3,204 in³ = 1.85 ft³.
- QUIKRETE Fast-Setting Concrete Mix lists a yield of about 0.375 ft³ (11 litres) per 50 lb bag, so one post takes 4.94 bags.
- Ten posts: 18.5 ft³, which is 49.4 bags, so 50 bags.
In metric, a 100 mm post in a 300 mm hole with 0.9 m of burial and the concrete stopping 75 mm below grade takes 0.0501 m³, or 50 litres per post. At 11 litres a bag that is 4.55 bags per post and 45.5 for ten, so 46 bags. The gravel for the ten holes comes to 3.9 ft³ (0.15 yd³), or 106 litres.
As a check on the yield figure, the QUIKRETE data sheet itself says two 50 lb bags set a 4 in post in a 10 in hole 2 ft deep. The same arithmetic gives 0.76 ft³ and 2.03 bags.
Pouring it: water and deep holes
With the post plumb and braced, pour the dry mix to 3 to 4 in (100 mm) below the top, then soak it with water. QUIKRETE gives about 1 gallon of water per 50 lb bag. Check plumb again before the mix sets.
For holes deeper than 2.5 ft, QUIKRETE says to add the mix in lifts of 2.5 ft or less and let the water soak through each one before adding the next. The 42 in hole above is deeper than that, so pour it in two steps. The fence calculator linked below sums the concrete for every post and rounds the bags once at the end.
Questions
How deep should a fence post be in the ground?
QUIKRETE says one third of the overall post length, plus 6 in (150 mm) of gravel. For a post with 6 ft above ground that is 3 ft of post plus 6 in of gravel, so a 42 in hole. Check local requirements for frost depth.
How wide should the post hole be?
Three times the post width, per QUIKRETE. A 4 in (100 mm) post needs a 12 in (300 mm) hole.
How many bags of concrete does one fence post need?
For a 4 in post in a 12 in hole with 33 in of concrete, about 5 bags of 50 lb QUIKRETE Fast-Setting mix (1.85 ft³ at 0.375 ft³ a bag). Smaller posts and holes need fewer.
Do I need gravel under the post?
QUIKRETE specifies 6 in (150 mm) of gravel or crushed stone at the bottom to help drainage.
How much water does the dry mix need?
About 1 gallon (roughly 3.8 litres) per 50 lb bag of Fast-Setting Concrete Mix, according to QUIKRETE. Soil conditions change the amount a little.
Calculate it
Fence calculator
Posts, panels or pickets and rails, concrete per post.
Fence calculator →Sources
- [1]Setting Posts – project instructions. QUIKRETE Companies. Hole diameter 3 times the post diameter; hole depth 1/3 of the overall post length plus 6 in (150 mm) of gravel at the bottom for drainage.. Checked November 6, 2026
- [2]QUIKRETE Fast-Setting Concrete Mix – SPEC-DATA sheet. QUIKRETE Companies. Hole depth one half of the above-ground post height; pour dry mix to about 3–4 in from the top and fill the rest with soil; yield about 0.375 cu ft (11 L) per 50 lb bag.. Checked November 6, 2026
- [3]Concrete Mix No. 1101 – Product Data Sheet. QUIKRETE Companies. Yield per bag: 40 lb ≈ 0.30 ft³, 60 lb ≈ 0.45 ft³, 80 lb ≈ 0.60 ft³. Checked November 5, 2026
- [4]SAKRET Premium-Beton – Technisches Merkblatt (2025-12-02). SAKRET. Yield 0.46–0.47 l of fresh concrete per kg; we use the lower value 0.46 l/kg (11.5 l per 25 kg bag). Checked November 5, 2026